AEM PERFORMANCE ELECTRONICS BOSCH LSU 4.9 REPLACEMENT 02 SENSOR

AEM's Bosch 4.9LSU Wideband UEGO O2 replacement sensor kit includes only the sensor (with attached cable and male connector) and is intended to replace an existing mounted wideband sensor used with AEM Digital Wideband UEGO Air/Fuel Controller Part Number 30-4110.

These sensors have a laser-etched, calibrated resistor in the sensor’s connector body. This resistor is specifically created for the exact sensor that it is attached to. Modifying this will invalidate the sensor’s output. The wideband sensor is laboratory-calibrated at the Bosch factory, accurate to 0.1 AFR and never requires free-air calibration when used with an AEM wideband AFR controller.

Features include:

• Accurate to 0.1 AFR.
• Never requires free-air calibration when used with an AEM Controller and connector plug.
• Specifically designed for use with AEM Wideband UEGO controller Part Number 30-4110.
  
  

Replacement Sensor for the following AEM Wideband Controllers:

• 30-4110 - Digital Wideband UEGO Gauge.
• 30-0300 - X-Series Digital Wideband UEGO AFR Gauge.
• 30-0310 - X-Series Inline Wideband UEGO AFR Controller.

Replacement Sensor for the following AEM Wideband Controllers:

• 30-4110 - Digital Wideband UEGO Gauge.
• 30-0300 - X-Series Digital Wideband UEGO AFR Gauge.
• 30-0310 - X-Series Inline Wideband UEGO AFR Controller.

Advanced Engine Management, Inc. warrants all of their products to be free from defects in material and workmanship for a period of 1 year. This warranty applies only to the original purchaser of the product and is non-transferable. AEM Power shall not be responsible for special, incidental, or consequential damages or cost incurred due to the failure of the product.