MAGNUSON GM LS3/LSA TVS2650 HOT ROD SUPERCHARGER KIT

The TVS2650 ‘Hot Rod’ kit for LS3 based engine applications is designed for all GM engines with LS3 heads. Designed to work with LS3 and LSA drive systems, this jackshaft-based system is geared for your high horsepower hot rod and race applications capable of up to 1,500HP, with appropriate engine and vehicle modifications.

Features:

• Magnuson TVS2650 Supercharger system complete with LS3 specific lower manifold, inter-cooler and jack-shaft drive system.
• 2.65L displacement Roots-type supercharger with Eaton TVS(r) Technology comprising of the high helix, four-lobe rotors for maximum supercharger efficiency across entire speed range, capable of 24,000rpm and 2.4 pressure ratio.
• Patent-pending Supercharger housing designed to deliver huge airflow at high engine speeds for maximum horsepower levels.
• Quick change, cartridge style jack-shaft system with high torque/low inertia carbon fiber driveshaft.
• High flow charge air cooler and massive 1-inch (-16ORB) ports reduce coolant restriction allowing maximum flow with extremely high cooling efficiency.
• The coolant ports accept most aftermarket fittings, allowing endless customization.
• High flow inlet duct designed for electronic throttles with GM LT5 bolt pattern.
• Also works with Magnuson’s 109mm mechanical throttle body P/N 98-05-40-007.Also compatible with 112mm Nick Williams throttle body.
• Set up for port injection fuel system with hard anodized, extruded aluminum fuel rails with ½” thru bore. Does not include injectors or fuel crossovers.
• Includes press-on hub for 2-piece pulley (not included) and interchangeable rear cog belt system allowing for drive ratio optimization.
• Supplied with standard 32 and 34 tooth cogs for up to 6% overdrive of front pulley.
• Additional 30-38 cog tooth pulleys available in two tooth increments.
• Fast response, vacuum bypass system designed to unload supercharger at engine idle speeds and allow inter-cooled air to be recirculated through the supercharger for rapid cool down.

Pulleys:

Note: All Magnuson supercharger systems are currently subject to an estimated lead time of 4-6 weeks from the date of order confirmation.

Designed to fit GM small block V8 engines with LS3 style cylinder heads and to work with LS3 and LSA drive systems. Vehicle fitment is the end user’s responsibility. Vehicle installation may require a new hood, or cut out in the hood to accommodate supercharger, plus possible cowl trimming.

3 year/36k mile limited warranty.